Conformities; Operation; Battery Pack - Ape Labs Apestick Bedienungsanleitung

ape labs apestick user manual

CONFORMITIES

Herewith, ape labs Lichtprodukte GmbH declare that the wireless Apestick
is in accordance with the basic requirements and the other relevant regula-
tions of the directive 1995/5/EC. The Apestick is licence-free and generally
approved for operation in EU, USA and EFTA countries.
LVD:EN60598,EN62031,EN62471
EMC:EN55015,EN60825,EN301 489
RF:EN300 220

OPERATION

BATTERY PACK

The device uses a lithium polymer battery pack. The battery supplies the
device with power for about 10 hours. However, you can use the Apestick
permanently connected to the mains.
The charging time for the battery pack is about 5 hours. The charging of
the battery pack is indicated at the upper part of the tube near the On- Off
button with a flashing green LED. This LED is integrated into the tube.
Green status light:
Slow flashing:
The battery pack is charging normally. The Apestick can be switched on.
Fast flashing:
The battery pack is charging normally, is however heavily discharged. The
Apestick cannot be switched on. After about 15 minutes of charging the
Apestick can be switched on again.
The green flashing light stops:
The battery pack is charged. The Apestick can be used.
Orange status light:
The battery pack performance is decreasing.
Only a few hours of operation might be left.
Red status light:
The battery pack is empty and has to be charged.
The Apestick switches off automatically.
ON AND OFF
To turn on and off, keep the button on one side of the Apestick pressed for
about 3 seconds.
20