Electrical Connection - Storch Mixx 25 Bedienungsanleitung

Whenever Machine Is Running
Do not allow a routine to set in (from fre-
quent use) and allow errors to be made.
Loss of attention for even microseconds
can lead to serious injury.
Caution!
• If the tool makes unusual noises or vibrates stron-
gly immediately stop and switch off the device.
Unplug. Do not start up again until the fault has
been identifi ed and rectifi ed.
• Keep the tool and workplace out of reach of all
visitors, observers and children.
Before setting the tool down: never leave the run-
ning tool unattended.
• Switch the tool off,
• Wait for all moving parts to stop,
• Unplug from power outlet.
When operating electric tools foreign particles can
be propelled into the eyes, leading to serious eye
injury. Before starting up the tool always put on
satefy goggles with side protection or full facial
protection if necessary. We recommend the use of
a visor to wear over prescription glasses or standard
safety glasses with side protection.
Make Workshop Child Proof
• Lock the workshop
• Switch off the mains switch
• Always store out of reach of children
or other unauthorised persons.
Caution!
Save these Instructions
Motor and Electrical Requirements
CAUTION: Use a proper circuit protection
to reduce the risk of electric shock, fi re or
damage to the tool. The tool is designed
to be operated in the above mentioned
voltages. Connect the tool to power cir-
Caution!
cuit with the correct voltage and connect
a 16 amp branch lead. Use a delay-action 16 amp
fuse or a safety switch. If the cable is worn, cut or da-
maged in any way it should be immediately replaced
to reduce the risk of fi re and electric shock.
Electrical Connections
The plug must be plugged into a
matching outlet that is properly installed
and grounded in accordance with all lo-
cal codes and ordinances. Do not modify
the plug provided. If it will not fi t the
outlet, have the proper outlet installed
Note
by a qualifi ed electrician.
Improper connection of the equipment-grounding
conductor can result in a risk of electric shock. The
conductor with insulation having an outer surface
that is green with or without yellow stripes is the
equipment-grounding conductor. If repair or replace-
ment of the electric cord or plug is necessary, do not
connect the equipment-grounding conductor to a live
terminal.
If the cable is worn, cut or damaged in any way it
should be immediately replaced by a qualifi ed electri-
cian. If the instructions on earthing are not clear or if
in doubt, this should be checked by a qualifi ed electri-
cian or by the STORCH service station.
Ensure that you do not touch the con-
nections of the plug when plugging in
and unplugging the tool, so as to pre-
vent injury or a potentially fatal electric
shock.
Caution!
41