Cleaning The Mixer - Storch Mixx 25 Bedienungsanleitung

Grip positions when starting up
Please be careful when starting up the electric mixe
Ensure you are holding it properly.
If the device is not placed properly on
the fl oor (e.g. with the cable facing
down) the mains cable can be dama-
ged, increasing the risk of electric show
and the risk of damage to the tool.
Caution!
Maintenance
Before servicing the tool disconnect the
power supply to reduce the risk of injury
from an unexpected start up or electric
shock.
Caution!
Keep the tool clean. Remove accumu-
lated dust from working parts. Make sure that the
tool operates properly. Periodically check screws and
bolts for tightness.

Cleaning the mixer

After about 50 running hours use pressurised dry air
to clean all ventilation slots. Regularly wipe plastic
parts with a soft, damp cloth. NEVER clean plastic
parts with solvents.
When working with pressurised air wear safety gog-
gles. After about 200 hours of running time the
lubricant should be replaced by a qualifi ed STORCH
Service Station.
Replacing Carbon Brushes
If worn down to 7 mm both carbon brushes should
be replaced. To check or replace the carbon brushes,
disconnect the tool from the power supply. Then un-
screw the four motor casing screws. Pull back the
carbon brush springs to release the tension. Release
the screw holding the carbon brush guide. Remove
the carbon brush.
Repeat for the other side. To reassemble reverse the
procedure.
The straps on the metal of the brush unit are fi tted
into the same opening as the carbon parts.
To fi t the same brushes fi rst ensure that
the brushes are replaced in exactly the
same way as before they were removed.
The motor performance can otherwise be
affected and the brushes will be subject
Note to more wear and tear. It is advisable to
send the tool to customer service unit
authorised by STORCH at least once a year for a full
clean and lubrication.
To ensure safety and reliability, all re-
pairs with the exception of carbon
brushes that can be externally access,
should be carried out in a customer ser-
vice centre authorised by STORCH.
Caution!
44