Storch Mixx 25 Bedienungsanleitung Seite 42

If not properly earthed this tool can
cause an electric shock especially if
used in damp conditions, near pipes or
outside. An electric shock can also cause
secondary dangers, e.g. if the operator
Caution!
is touching the mixer.
Motor Safety Protection
Important: To prevent damage to the motor this mo-
tor has to be regularly blown out or vacuum cleaned
so that the normal motor ventilation is not affected
by dust.
1. Connect this tool to a power source with the ap-
propriate voltage for your model and a 1 6-amp
branch circuit with a 16-amp time delay fuse or
circuit breaker.
2. If the motor won't start, turn the switch "OFF"
immediately and unplug the tool.
3. If the motor suddenly jams during mixing, release
the switch and unplug the tool. The motor can
then be restarted.
4. For the following
ten blow or safety
a)Motor has overheated - this can occur if fi lling up too
fast or if the tool is started up and stopped frequently.
b)Line voltages should not be more than 10%
above or below the nameplate voltage. For heavy
loads, however, the voltage at motor terminals
must equal the voltage specifi ed for your model.
5. Most motor damage can be attributed to loose or
faulty connections, overload or too low voltage
(e.g. if the lead cross section in the mains power
is too small) or excessively long leads in the pow-
er supply. If the motor is not operating smoothly,
always check the connections, the load and the
power supply cycle. The lead cross section should
not be less than 2.5 mm2.
reasons fuses can of-
switches shut down
Unpacking and Checking Contents
Unpacking
To minimise the risk of injury by unex-
pected start-up or electric shock during
unpacking and fi tting the plug, do not
plug in. The mains cable always has to
be unplugged if working on the tool.
Caution!
The tool is supplied in a box.
• Remove the tool and all loose parts from the car-
ton.
• Place all parts on a secure, stationary work sur-
face and look the machine over carefully.
Before assembly check to ensure that no
parts are missing. If some are missing,
do not assemble. Check the packaging to
see if the missing parts are still in there.
There is a full list of parts at the end of
these instructions. Use the list to identify
Note
any missing parts.
If any parts are missing do not use the
electric mixer until the parts have been
replaced. This could otherwise result in
severe injury.
Caution!
42