SilverCrest SGKT 50 A2
Handset locator
This features lets you locate your handset if you have misplaced it. While the base is in standby
mode, press the Locator button [25]. The handset emits a tone for approx. 30 seconds and the Call
LED [13] flashes. The locator ring will sound even if the ringtone has been disabled.
To disable the tone and the flashing Call LED [13] press any button on the handset.
Troubleshooting
Handset does not work / blank
display
The antenna icon
No ringtone from handset or
base
No ring or dial tone for outgoing
calls
The time and date display flash
on the base
When using the pulse dial mode with a PBX, it is possible for malfunctions to occur.
This is because the PBX misinterprets the dial pulses. Switch to tone dial mode.
46 - English
Batteries inserted incorrectly - insert the rechargeable
batteries with the correct polarity.
Batteries are flat - recharge the batteries.
is flashing
Handset out of range – take the handset closer to the
base.
Base has no power – check the base power supply.
Switch the ringtone back on.
The phone cord is defective.
Time and date have not been entered. Enter the time
and the date.
The power supply has been interrupted. Enter the time
and the date again.