Calling A Number From The Phonebook; Internal Calls; Redial; Answering Incoming Calls - Silvercrest SGKT 50 A2 Bedienungsanleitung

SilverCrest SGKT 50 A2

Calling a number from the phonebook

If you want to use a number stored in the phone book, press the Phonebook button [19] while in
standby mode. Press the  or  multifunction control buttons [16] to select the desired entry and
then pick up the receiver to call the selected entry.
Put down the receiver to end the call.
You can also pick up the receiver first and then dial the number from the phonebook. To do this,
press the Phonebook button [19] and then use the  or  multifunction control buttons [16] to
select the desired entry. Next press the Menu/OK button [15] to confirm your selection. Press the
 or  multifunction control buttons [16] to select the "DIAL NUMBER" menu item and then press
the Menu/OK button [15] to call the selected entry.
For more information about adding a new phone book entry, please read the
chapter "PHONEBOOK" on page 28.

Internal calls

To make an internal call, do not pick up the receiver and press and hold the Locator (internal call)
button [25] for approx. 3 seconds (a short beep can be heard). "INT" will appear on the display
[17]. Next enter the number of the handset that you want to call. The connection will be established
immediately after entering the number. After the connection has been established, you can also
pick up the receiver to make the call.

Redial

Press the button on the multifunction control [16] to show a list with the last three dialled phone
numbers.
To call the last dialled phone number again, simply pick up the receiver, as the last phone number
is already highlighted.
To call any other number on the list, press the  or  multifunction control buttons [4] to select the
desired number and then pick up the receiver to call it.
When picking up the receiver first before pressing the
control [16], the last dialled number will be redialled automatically.

Answering incoming calls

When receiving a call, the number of the caller will be shown on the base display [17] and the
Call LED [23] flashes. If the phone number has been saved in the phonebook, the corresponding
name will be shown. The requirement for this feature to work is that your phone line must have the
Caller ID function enabled.
Pick up the receiver to answer the call.
40 - English
button on the multifunction