Maintenance And Care - AL-KO JET F 1004 Betriebsanleitung

en

MAINTENANCE AND CARE

CAUTION!
Before beginning any maintenance or
cleaning work, make sure that the pump
has been unplugged and take precauti-
ons to ensure that it cannot be switched
on during work!
Cleaning the pump
If you have used your garden pump to pump chlo-
rine water (swimming pool water) or liquids which
leave a residue, flush your pump out with clear
water after use.
Cleaning the filter
CAUTION!
The seal (16) must be correctly inser-
ted in the seal seat on the pump head
(see Detail in Fig. D). If necessary lightly
grease the seal with non-acidic fat.
1. Remove the screw plug (10) from the drai-
nage opening, empty the filter chamber and
close the drainage opening again.
2. Unscrew the filter cover (11) with the help of
the filter spanner.
3. Remove the filter (13) from the pump head
and clean it under flowing water.
4. Prior to installing the filter, check the two seals
(12) on the filter and the seal (16) for damage,
if necessary renew.
5. Install the filter, screw on filter cover and tigh-
ten firmly with the hand using filter spanner.
14
Removing and mounting of non-return valve,
cleaning
1. Remove the filter (see Section "cleaning the
filter").
2. Unscrew the non-return valve (14) and clean
it under flowing water.
3. Renew seal (15) if necessary.
4. Install the non-return valve.
5. Install the filter and filter cover.
Frost protection
Your domestic water system is susceptible to low
temperatures. Make sure to empty the device of
residual liquid (hoses, pump and reservoir) and
store it so that it is protected from frost.
1. Empty the suction and pressure hoses.
2. Remove the draining screws (9) and (10)
drain all water from the pump chamber. The
water contained in the reservoir will be pres-
sed out by the air bellows.
3. Replace the draining screws and store the de-
vice so that it is protected from frost.
DISPOSAL
Do not dispose of worn-out machines
or spent batteries (including recharge-
able batteries) in domestic waste!
The packaging, machine and accessories
are made from recyclable materials and
must be disposed of accordingly.
Maintenance and care
477 217_b