Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4. Operation
Flood Sensor is used to monitor flooding or water leakage. When water is
detected , the sensor will transmit a signal to the control panel to notifiy
the user.
Refer to the AS-200 Series User`s Instructions for detail information regar-
ding the operation of this Flood Sensor with the control panel.
5. Sensor Failure / Low Battery Indication
The control panel constantly monitors its sensors, if the control panel fails
to communicate with any sensors, it will begin rapidly flashing the zone LED
indicator.
When sensor failure occurs, try the following:
1. Check if the sensor is located at where it should be, and whether there is
any physical damage to the sensor.
2. If the failed sensor is not physically damaged, try to activate the sensor
and see if the control panel reacts to such activation.
3. If not, try to remove the sensor from its location and bring it closer to
control panel and activate the sensor. It is possible that the sensor is
installed too far from the control panel and it cannot establish a steady
communication with the control panel. If this is the case, please install the
sensor closer to be control panel.
4. Replace the battery of the sensor in that zone if the Control Panel does not
respond when the sensor is activated within short range.
If you have multiple sensors in a zone, you may test the function of each
sensors to identify which sensor is having problem.
12
Registration and Safety Certification/General Information
This device bears the CE symbol as specified by the provisions of Directive R
& TTE (1999/5/EC).
Hama GmbH & Co. KG hereby declares that this device is in compliance with
the basic requirements and other relevant guidelines and regulations of the
1999/5/EC guideline. You will find the declaration of compliance and declaration
of conformity in the Internet at http://www.hama.com
13
Werbung
