Hama WS-200 Bedienungsanleitung Seite 6

Step 4:
You will hear a long beep and the zone LED stops flashing. The sensor is now
programmed to the Control Panel.
Note:
You may program up to 4 sensors to on zone.
Zone 4 is an alert zone, sensors in this zone is fort alert purpose ONLY and
will not trigger the alarm.
Test Sensor
After learning the sensor to the control panel, you may test the communica-
tion by placing the sensor into the water and removing it from the water.
When the sensor is not in the
water, the receiver will not beep
1. Zone LED of this sensor will flash
2. Beeping according to the zone number (Alert Notification Switch is set
to "Alert"). 1 beep for zone 1, 2 beeps for zone 2 etc. until the sensor is
removed from water.
Note: If the Alert Notification Switch is set to "Chime", Control Panel will
chime once for every signal activation. If the Alert Notification Switch is set
to "OFF", no audio alert will sound.
10
When the sensor is in the
water, the receiver will beep
and a LED will flash.
3. Installation
A clean smooth surface is required to mount the flood sensor securely.
Mount the transmitter portion and sensor portion to the appropriate location
with double sided foam tape respectively.
If the mounting surface is not smooth or clean enough for the doubled sided
tape, you may screw the plastic plate onto the surface, which then provides
a smooth & clean surface for the double sided tape.
Always mount the transmitter portion at least 6 inches above the sensor
portion.
Rough surface
Plastic plate
with screws
Double sided
tape
Testing:
After mounting the sensor, test the sensor by placing it into the water and
removing it from the water. The Control Panel should respond in the same
way as described above, "Test Sensor".
Flood Sensor
11