Werbung
Verfügbare Sprachen
Verfügbare Sprachen
g Operating instruction
1. Introduction
The Flood Sensor is designed to detect water overflow, water leakage, or
rising water, such as the water level of your bathtub. It works in conjunction
with AS-200 Series Control Panel. When water is detected, the control panel
will either alert you or alarm will be triggered.
In this package, you should find a flood sensor, a 3V lithium battery installed
and other mounting accessories.
Flood Sensor
Transmitter
3V Lithium battery
Sensor
2. Learn Sensor to AS-200 Series Control Panel
In order for the sensor to communicate with the control panel properly, the
sensor must be programmed to the control panel. Follow the brief instruc-
tions below or refer to the detail instructions from the AS-200 Series. User`s
Instructions to program the sensor to the control panel. Before proceeding,
please remove the battery isolator from the sensor, and have a glass of
water ready.
Step1:
Press and hold the Learn Button on the Control Panel for 3 seconds.
Control Panel beeps once and you may release the Learn Button.
8
Mounting Accessories
Press 3 sec.
Step2:
Press the zone button (1, 2, 3 or 4) once, for which you want to program the
sensor to. The selected Zone LED will flash.
Press the zone button
Step 3:
Activate the Flood Sensor by placing the sensor portion into the water
Place sensor
into water
Transmitter
portion
Sensor portion
Long Beep
Zone LED flashing
C
Control Panel long beep
Z
Zone LED flashing OFF
Note: The transmitter portion should
never Be submerged in water.
9
Werbung
