Technical Data; Electric Supply; Function Of The Unit; Fitting The Drill Bit (A) - Rothenberger RODIADRILL 1800 DRY Bedienungsanleitung

Do not touch a damaged or severed power supply cord when working; pull the plug out of the
power socket immediately instead. Never operate the device with a damaged power supply
cord.
Before beginning your work consult the responsible structural designer to establish the exact
position of the hole to be drilled.
When drilling through a ceiling secure the area from below because the diamond core bit can fall
out.
2

Technical Data

Nominal power output ....................................... 1800 W
No-load speed .................................................. 1700 min
Speed under load ............................................. 1150 min
Oscillation ......................................................... 23000 min
Drilling capacity in concrete .............................. 32 – 202 mm
Tool reception ................................................... 1.1/4" UNC + G 1/2"
Weight without cable ......................................... 5,8 kg
Protection class ................................................ II
Type of protection ............................................. IP 20
Method of operation .......................................... S3
Operator safety coupling ................................... yes, electronic limit
Noise pressure level (L
Sound power level (L
The noise level during operation can exceed 85 dB (A). Wear hearing protection!
Measured values determined in accordance with EN 60745-1:2010.
Vibration total value .............................................................
The vibration level given in this information sheet has been measured in accordance with a
standardised test given in EN 60745 and may be used to compare one tool with another. It may
be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main applications of the tool.
However if the tool is used for different applications, with different accessories or
insertion tools or is poorly maintained, the vibration emission may differ. This may
significantly increase the exposure level over the total working period.
An estimation of the level of exposure to vibration should also take into account the
times when the tool is switched off or when it is running but not actually doing the
job. This may significantly reduce the exposure level over the total working period.
Identify additional safety measures to protect the operator from the effects of vibra-
tion such as: maintain the tool and the accessories, keep the hands warm, organisa-
tion of work patterns.
3

Electric supply

Connect only to single-phase a.c. current and only to the system voltage indicated on the rating
plate.
It is also possible to connect to sockets without an earthing contact as the design conforms to
safety class II.
4

Function of the Unit

4.1 Fitting the drill bit
Ø 32 - 202 mm (Hollow drill core bits):
 Screw the drill core bit in position.
12
) ................................. 92 dB (A) ¦ K
pA
) ................................... 103 dB (A) ¦ K
WA
ENGLISH
-1
-1
-1
3 dB (A)
pA
3 dB (A)
WA
2 2
5,5 m/s ¦ K= 1,5m/s
(A)