Inhaltsverzeichnis
Werbung
Anleitung NHS 700_SPK1
GB
1. General safety information
Caution! When using electric tools it is
imperative to take the following basic safety
precautions in order to reduce the risk of
electric shock, injury and fire. Read and
take note of these instructions before you
use this tool.
1. Keep your work area tidy
- An untidy work area invites accidents.
2. Check the working conditions
- Do not expose electric tools to rain. Never
use electric tools in damp or wet locations.
Make sure there is good lighting. Do not
use electric tools near flammable liquids or
gases.
3. Guard against electric shock
- Avoid body contact with earthed compo-
nents such as pipes, radiators, cookers, ref-
rigerators.
4. Keep children away!
- Do not allow other persons to touch the
tool or cable. Keep all persons out of your
work area.
5. Store tools in a safe place
- When tools are not in use they should be
stored in a dry, locked room out of child-
ren's reach.
6. Do not overload your tools
- Tools work better and safer when used
within their quoted capacity range.
7. Use the right tool
- Never use tools or attachments with insuf-
ficient power for the job in hand. Never use
tools on jobs for which they were not inten-
ded.
8. Wear suitable work clothes
- Do not wear loose clothing or jewelry as
they may get caught in moving parts.
Rubber gloves and non-slip shoes are
recommended when working outdoors.
Wear a hair net if you have long hair.
9. Wear safety goggles
- and use a dust mask when working on
dusty jobs.
10. Do not mis-use the cable
- Do not carry the tool by its cable or pull on
the cable to remove the plug from the
14
01.09.2006
11:37 Uhr
11. Don't overreach
12. Look after your tools
13. Always pull out the power plug
14. Remove adjusting keys and wrenches
15. Avoid unintentional starting
16. When using an extension cable outdo-
17. Be alert at all times
18. Check the tool for damage
Seite 14
socket-outlet. Protect the cable from heat,
oil and sharp edges.
- Avoid abnormal working postures. Make
sure you stand squarely and keep your
balance at all times.
- Keep your tools sharp and clean for better
and safer performance. Follow the instruc-
tions for maintenance work and for chan-
ging any attachments. Check the plug and
cable regularly and, if damaged, have them
replaced by an authorized specialist. Check
the extension cable regularly and replace it
if damaged. Keep handles dry and free
from oil and grease.
- when the tool is not being used, before
carrying out any maintenance work and
when changing attachments such as bla-
des, bits and cutters of any kind.
- Make sure that all keys and adjusting
wrenches are removed from the tool before
switching it on.
- Never carry a tool with your finger on the
switch if it is connected to the power supply.
Make sure that the switch is in OFF position
when inserting the power plug.
ors
- check that it is approved for outdoor duty
and is marked accordingly.
- Watch what you are doing. Use common
sense. Do not operate the tool if your mind
is not on your work.
- Each time before re-using the tool,
carefully check that the guards or any
slightly damaged parts are working as
intended. Check that the moving parts are
in good working order, that they do not jam,
and that no parts are damaged. Make sure
that all parts are fitted correctly and that all
other operating conditions are properly ful-
filled. Unless otherwise stated in the opera-
ting instructions, damaged guards and parts
have to be repaired or replaced by an aut-
Werbung
Inhaltsverzeichnis
