Inhaltsverzeichnis
Werbung
Anleitung NHS 700_SPK1
4. Technical data
Voltage
Power consumption
Cutting length
Cutter rail length
Tooth spacing
max. cutting ø
n
:
0
Cuts/min
Sound power level L
WA
Sound pressure level L
pA
Vibration a
hv
Weight
5. Voltage
The machine can only be run on single-phase
alternating current with 230V ~ 50Hz a.c. volt-
age. Before you use the machine for the first
time, check that the mains voltage is the same
as the operating voltage shown on the machine
rating plate.
6. Using for the first time and
operation
Important! This hedge trimmer is designed for
the trimming of hedges, bushes and shrubs. If it
is used for any other purpose not expressly
permitted by these operating instructions there
may be a risk of damage to the hedge trimmer
or serious injury to the user. The hedge trimmer
comes with a two-hand safety switch. It only
works if the switch on the guide handle (Fig. 3 /
Item 4) is pressed with one hand and either the
switch on top of the handle (Fig. 3 / Item 8) or
the switch below the handle (Fig. 3 / Item 9) is
pressed with the other hand.
Releasing any of the switches will bring the
hedge trimmer to a stop.
01.09.2006
11:37 Uhr
b
230V ~ 50Hz
710 W
600 mm
660 mm
24 mm
20 mm
1600 min
-1
3200/min
99,4 dB
86,4 dB
front handle 6,8 m/s
2
rear handle 9,06 m/s
2
4,3 kg
b
In so doing, please check the running of the
blades.
-
-
-
Seite 17
Rotary rear handle (Figures 4-8)
The hedge shears are fitted with a rear
rotary handle. This can be turned counter-
clockwise through 90° and clockwise
through both 90° and 180°. For this purpose
the top slide (6) must be pushed backwards
in the direction indicated by the arrow
(Figure 4). Then pull the slide (10) in the
direction indicated by the arrow and turn the
handle. If you turn it counter-clockwise the
handle will lock at an angle of 90° (Figure
7). If you turn it clockwise the handle will
lock at an angle of 90° and 180° (Figure 8).
Pull the slide (10) in the direction indicated
by the arrow again to return the handle to
its original position. When the handle is
back in its standard position the top slide
(6) must be pushed forward to lock it.
For vertical cutting the handle should be set
to 90° and for overhead cutting it should be
set to 180°.
Attaching the trimmings collector (Fig.
16/17)
Place the trimmings collector on the cutter
rail (Fig. 16). Then slide the trimmings
collector towards the tip of the cutter as far
as the stop and tighten the fastening scr-
ews (A) (Fig. 17). The trimmings collector
can be fitted either on the left-hand or the
right-hand side.
Please check that the blades function cor-
rectly.
The blades cut on both sides and run in
opposite
directions to each other, for guaranteed
high
cutting performance and quiet operation.
Fasten the extension cable to the cable
holder
before starting to use the machine (see Fig.
9).
For use in the open air you must only use
extension cables certified for the purpose.
GB
17
Werbung
Inhaltsverzeichnis
