Operation; Selecting The Indoor Temperature Display (Temperature/Dew Point); Selecting The Outdoor Temperature Display (Temperature/Dew Point/Wind Chill); Selecting The Outdoor Sensor - elv WS 300 Bedienungsanleitung

3.2. Operation

Selecting the indoor temperature display
In normal mode the "INDOOR" display field shows the indoor temperature and
indoor humidity.
- By repeatedly pressing the "IN" key, you can switch between displaying the indoor
temperature and the associated dew point value:
→
Indoor temperature
Selecting the outdoor temperature display
In normal mode the "OUTDOOR" display field shows the outdoor temperature and
outdoor humidity of the chosen outdoor sensor.
- By repeatedly pressing the "OUT" key, you can switch between displaying the
outdoor temperature and the associated dew point value or the perceived
temperature (wind chill):
→
Outdoor temperature

Selecting the outdoor sensor

The "Sensor" display field shows the outdoor sensor you have just selected, along
with its address. Only active sensors (received in the synchronisation phase) are
displayed.
The outdoor sensors 1 to 8 (ASH 2200) and the combi-sensor (no address shown)
can be displayed.
- You can select the desired sensor by repeatedly pressing the "SENSOR" key.

Selecting the rainfall display period

- By repeatedly pressing the "RAIN" key, you can switch between the indication for
the last hour, the last 24 hours or the total quantity since the last reset or since the
batteries were inserted:
→ →
1 h

Resetting the total rainfall quantity

- Press and hold the "RAIN" key down for about 2 s to reset the total rainfall quantity
immediately after the key is released.
→
Dew point
→
→
24 h Total
→
Dew point Wind chill
43