Preparation For Operation; The Outdoor Sensors - elv WS 300 Bedienungsanleitung

2. Preparation for operation

Start up all outdoor sensors first, then the base station.

2.1. The outdoor sensors

The following outdoor sensors are available for the weather station:
- KS 300 combi-sensor: This is a permanently addressed combination sensor
consisting of rain sensor, instant rain detection sensor, wind speed sensor, outdoor
temperature/humidity sensor and integrated transmitter unit. Operation is by means
of three Mignon batteries.
- ASH 2200 outdoor temperature/humidity sensor: Addressable sensor, battery-
operated (2 Mignon batteries). Up to 8 sensors of this type can be used for opera-
tion on the WS 300.
Commissioning
KS 300
The KS 300 is commissioned according to the following procedure:
- Assemble the plug mast of the sensor by screwing the individual tubes together
using the threaded adapters, insert the earth spike at the base and screw the
sensor holder on at the top.
- Open the housing of the sensor by turning the housing anticlockwise and pulling
from underneath (see picture bottom left).
- Insert three Mignon batteries into the battery compartment as indicated by the
pole markings in the compartment.
To detach:
Turn to the left,
remove from
underneath
To attach:
Attach,
turn to the right
+
–
+ –
Bottom
35
–
+