In configuration mode the keys have the following functions:
IN
SENSOR
MIN/MAX
RAIN
OUT
This key assignment is also shown on the rear of the weather station.
Please note!
If you press and hold down the "+" or "-" keys during the individual setting opera-
tions, the figures will run through more quickly.
After every setting operation you can either leave configuration mode by pressing
the "EXIT" key or proceed to the next setting via the "NEXT" key.
Configuration is performed in this order:
→
→
Year
Month
→
Deg. longitude (LO = Longitude)
→
Rain quantity unit
IN
+
–
NEXT
+
–
NEXT
→
not used
→
EXIT
→
+
→
–
→
NEXT
→
→
Day
Minutes
→
Assignment of indicator path
[2 seconds]
Year
Month
Leave configuration mode
Increase value
Decrease value
To the next setting
→
→
Hours
→
Time zone (ti)
Calling up configuration mode
Configuration mode is called up by holding
the "IN" key down for about 2 seconds. When
the key is released the corresponding display
is shown.
You can leave configuration mode at any time
as described in "Leaving configuration
mode".
Setting the date and time
Set the current year using the "+" and "-" keys.
Press "NEXT" to go to the month setting.
Set the month using the "+" and "-" keys.
Press "NEXT" to go to the day setting.
38
Deg. latitude (LA = Latitude)
→
Rain sensor calibration
→
Wind unit