Herunterladen Diese Seite drucken

VQ Model Taipan Montageanleitung Seite 12

Werbung

20- Installation the wing
6X50mm bolt
...2
21- Balance
22- Control surface
AILERON STROKE / QUERRUDER
BEFORE FLYING CHECK EVERYTHING
Before each flight, inspect the airplane for any loose parts. Check the hinges, make sure the pushrods are still firmly
attached, and check the engine mounting bolts. In general, check everything on the plane that might possibly come
loose.
Nylon bolt 6x50mm
Der Schwerpunkt sollte zwischen 88 mm und 92 mm
hinter der Nasenleiste liegen. Für die ersten Flüge
empfiehlt es sich, den Schwerpunkt an den vorderen
angegebenen Punkt zu legen.
Falls erforderlich muss dies durch Ankleben von Blei
erreicht werden.
WARNING ! Securely install the receiver and power
pack, ensuring they will not come loose or rattle during
flight.
Never fly before checking the Cg's required position.
ELEVATOR STROKE / HOHENRUDER
1/4"(6mm)
1/4"(6mm)
RUDDER STROKE / SEITENRUDER
13/32"(10mm)
13/32"(10mm)
1.4"(35mm)
1.4"(35mm)

Werbung

loading