Werbung
18- Electric Motor
116~118mm
A
Fire wall
A'
A=A'
Aluminum Mounting plate.
19- Wing shield
Using the ABS bottom wing shield as a template,
trace around the outside edge of the
ABS bottom wing shield and then remove it.
Using a sharp hobby knife, cut away
the covering inside the lines. Not to cut into the
wood.
Apply the ABS bottom wing shield in place and
secure it with CA glue.
1
CA
SIDE-VIEW
Using a aluminum motor mounting plate as
a template, mark the plywood motor mounting
plate where the four holes are to be drilled (2).
Remove the aluminum motor mounting
plate and drill a 1/8"(3mm) hole through
2
the plywood at each of the four marks
marked .
3mm
Note: The aluminum motor mounting included
with electric motor set.
TOP-VIEW
B
B'
! Engine thrust on balk head
B=B'
CA
is already adjust at factory
Cut away the covering
inside before install the
bottom wing shield.
Werbung
