Programming With Märklin Mobile Station - roco FS 653 Handbuch

5. Press the knob.
6. Choose the address of the locomotive
7. Press the knob.
In the case that the locomotive does not run, erase the locomotive from the databank:
1. Press the ESC button
2. Choose the menu option (Erase Locomotive)
3. Press the knob
4. Press the knob again to con�rm
Repeat the steps
"Dock the Locomotive in the databank" (1-8) and "Setting the Correct Address" (1-7)
Should there still be problems, delete the locomotive from the databank again.
Repeat the steps
"Dock the Locomotive in the databank" (1-8), except that at step 5 you go to the menu option ("Address"),
and at step 7 you should set the address of your locomotive.
Look for the desired symbol with the knob, and con�rm your choice with the knob.
The functions F1 – F4 can be accessed with the 4 left side buttons on the Mobile Station. The top button
is for function F1. However, the activated functions cannot be shown in the display.
▪ Programming with Märklin
1. Press the "ESC" button
2. Rotate to the right "EDIT LOC" --> press OK
3. Rotate 2x to the left to "REG" --> press OK
4. Rotate until the required CV �ashes --> press OK
5. Rotate until the required value �ashes --> press OK
The locomotive con�rms the programming by �ashing brie�y.
The carriage con�rms the programming by the interior lighting �ashing and with additional sounds.
30
30
8072112920.indd 30
Mobile Station
1)
24.08.2012 13:21:55