SkyLine Ride Handbuch Seite 27

Adjusting the leg loops:
Adjusting the leg loops takes place each time again when putting on the harness.
You have to pay attention to always tightening the leg loops firmly.
Note: You always have to pay attention to the correct engaging of the clicking
latches! Tighten the leg loops again before launching, so that the seat board
remains fixed within the range the thigh. They prevent thereby the sliding-up of
the seatboard and to get faster in a seating position.
Adjusting the lateral chest belt:
Adjusting the lateral chest belt makes possible to vary the back support. As it is
the case on each bucket seat, every pilot may vary desired back support and
bend line of its backbone. The flight position can be adjusted also during the flight
which serves avoiding possible arising back problems during longer flights.
Note: The more stretched the pilot lies in the harness, the more sluggish is he
moving regarding to the canopy. In extreme cases this can strengthen the danger
of pivoting the lines.
The RIDE got a lateral chest belt at each side. The pilot can change his seating
position also during the flight quickly and uncomplicated by flat latches. The
relatively high set lateral chest belt provides an effective back support and takes
the pressure of the shoulders.
(upright position)
closer
skyline-flightgear.de
more open
(lying position)
red arrow = pulling direction
5 5