Yamaha NS-M525 Bedienungsanleitung Seite 3

Before making connections, make sure that the amplifier is switched off.
Loosen
Black (–)
Insulation coating
NS-M525
(R)
SPEAKERS
R
Speakers output
terminals of the
+ –
amplifier (or
receiver)
Amplifier or
Receiver
When using a banana plug
Banana plug
2
CONNECTIONS TO YOUR AMPLIFIER
Tighten
Red (+)
Bare wire
NS-M525
(L)
L
A
– +
B
3
1
• Connect the screw-type input terminals at the rear of the
speakers to the speaker output terminals of the amplifier
(or receiver) with the speaker cable.
• Connect the (+) terminals on the amplifier (or receiver)
and the speakers using one side of the cable. Connect
the (–) terminals on both components using the other
side of the cable.
• Connect one speaker to the left (marked L) terminals of
your amplifier, and another speaker to the right (marked
R) terminals, making sure not to reverse the polarity
(+, –). If one speaker is connected with reversed polarity,
the sound will be unnatural and lack bass.
How to connect:
1 Loosen the knob.
2 Remove the insulation coating at the extremity of each
speaker cable by twisting the coating off.
3 Insert the bare wire.
4 Tighten the knob and secure the cables.
Test the firmness of the connection by pulling lightly on
the cables at the terminal.
Note:
• Do not let the bare speaker wires touch each other as
this could damage the speaker or the amplifier, or both
of them.
• Do not insert the insulation coating into the hole.
The sound may not be produced.
1 Remove the cover by pulling it toward you.
2 Tighten the terminal knob.
3 Simply insert the banana plug into the terminal.
3
E-