Yamaha NS-B500 Bedienungsanleitung Seite 4

■
Mounting the speaker
• Wall-mount via the attached mounting
bracket
Fasten commercially-available screws into a firm wall or
wall support as shown in the figure, and hang the holes of
the mounting bracket on the protruding screws.
Note
Make sure that the screws are securely in the narrow sections
of the holes.
Diameter: 3.5 – 4 mm
Commercially-available
self-tapping screw
Side view
3 mm
(1/8")
4
En
• Wall- or ceiling-mount via a commercially-
available speaker bracket
You can use the screw holes on the rear of this unit for
installing the speaker to a commercially-available speaker
bracket (if you do not use the factory-attached mounting
bracket).
Please refer to the owner's manual that came with your
speaker bracket.
(1/8" – 3/16")
Screw hole for bracket
If you use a bracket that
features four holes, affix
the bracket using four
screws.
Diameter:
6 mm (1/4")
Hole depth:
20 mm (3/4") or
15 mm (5/8")
longer
If you use a bracket that
40 mm
features two holes, affix
(1-5/8")
the bracket using these
two screw holes.
• Using a commercially-available speaker
stand
If you mount the speaker on a commercially-available
speaker stand, use the mounting screw holes on the bottom
of the speaker.
Rear view
Screw holes
Diameter:
4 mm (3/16")
Hole depth:
10 mm (3/8")
Notes
• Do not mount the speakers on thin plywood or on a wall with
a soft surface material. Otherwise, the screws may pull out of
the surface and the speakers may fall, possibly damaging the
speakers or causing personal injury.
• Do not install the speaker on a wall using nails, adhesives, or
any other unstable hardware. Long term use and vibration
may cause it to fall.
60 mm
• If you use a commercially-available bracket, choose one that
(2-3/8")
would reliably supports the speaker's weight (3.5 kg; 7 lbs.
11 oz.).
• Be careful not to pinch the speaker cables between the
speaker and the speaker bracket or speaker stand.
• To avoid accidents resulting from tripping over loose
speaker cable, affix them securely to the wall.
• Placing the speakers too close to a CRT-type TV may impair
the picture color or cause a buzzing noise. In this case, move
the speakers away from the TV. This is not an issue with
LCD and plasma TVs.
Bottom view
(Front)
(Rear)