Attaching The Grille; Specifications - Yamaha NS-C901 Bedienungsanleitung

ATTACHING THE GRILLE

The speaker and the grille are packed separately.
To attach the grille, line up the four salients (magnet) on the
reverse side of the grille with the four corresponding pegs.
Notes
• When the grille is not attached, take care not to
touch the speaker units with your hands or to exert
excessive force with tools.
• There are magnets on the reverse side of the
grille. Do not place the grille close to objects that
might be affected by magnets, such as TVs, clocks,
magnetic cards, diskettes etc. when you don't use
it.
English
Information for Users on Collection and Disposal of Old Equipment
This symbol on the products, packaging, and/or accompanying documents means that used electrical and
electronic products should not be mixed with general household waste.
For proper treatment, recovery and recycling of old products, please take them to applicable collection points,
in accordance with your national legislation and the Directives 2002/96/EC.
By disposing of these products correctly, you will help to save valuable resources and prevent any potential
negative effects on human health and the environment which could otherwise arise from inappropriate waste
handling.
For more information about collection and recycling of old products, please contact your local municipality,
your waste disposal service or the point of sale where you purchased the items.
[Information on Disposal in other Countries outside the European Union]
This symbol is only valid in the European Union. If you wish to discard these items, please contact your local
authorities or dealer and ask for the correct method of disposal.
3
En

SPECIFICATIONS

Type . ................................2-way bass reflex speaker system
Driver ..........................................13 cm (5") cone woofer x 2
3 cm (1") Aluminum dome tweeter
Impedance ...................................................................... 6 Ω
Frequency Response ....................56 Hz to 50 kHz (–10 dB)
Nominal Input Power ..................................................... 50 W
Maximum Input Power . ................................................ 200 W
Sensitivity . ..................................................... 90 dB/2.83 V/m
Crossover Frequency ................................................ 4.2 kHz
Dimensions (W x H x D) ........................500 x 170 x 271 mm
Weight ........................................................ 8.4 kg (18.5 lbs.)
• Specifications subject to change without notice due to
product improvements.
• Care should be taken not to exceed the input power
values noted above.
Taking care of the speaker
To maintain the spotless glossy surface of the
polished finish, wipe it with a soft, dry cloth. To
avoid damage to the finish, do not apply chemical
solvents, such as alcohol, benzine, thinner,
insecticide, etc. Also, do not use a damp cloth, or
any type of cloth that contains chemical solvents, or
place a plastic or vinyl sheet on top of the speaker.
Otherwise, the finish may peel, the color may fade,
or the sheet may stick to the surface.
non magnetic shielding type
to 100 kHz (–30 dB)
(19-5/8" x 6-3/4" x 10-5/8")