Attaching The Protectors; Specifications - Yamaha NS-5000 Bedienungsanleitung

■ When using a banana plug
The speaker and the protectors are packed separately.
To attach the protector, line up the salients (magnet) on the reverse side of the protector with the corresponding pegs.
Type.......................................................................3way bookshelf
Driver .........................................Woofer: 30 cm (12") cone type
Midrange: 8 cm (3-1/4") dome type
Tweeter: 3 cm (1-1/4") dome type
Impedance ............................................................... Nominal 6 Ω
Frequency response ........................... 26 Hz - 40 kHz (–10 dB)
* The contents of this manual apply to the latest specifications as of the publishing date. To obtain the latest manual,
access the Yamaha website then download the manual file.
* Care should be taken not to exceed the input power values noted above.
The rating label that states the serial number, etc., is affixed to the bottom of the speakers.
* The left speaker and the right speaker have the same serial number.
Banana plug
1
2

Attaching the protectors

Note
• When removing or attaching the protector, be careful not to touch the
drive units, and not to exert excessive force with any tools.
• Do not touch or apply impact to the speaker's diaphragm. Otherwise, the
speaker may malfunction.
• When removing the protectors, be careful that they do not hit the
speaker. Otherwise, the surface of the speaker may be scratched.
• Use both hands when removing or attaching the protectors to prevent
them from falling. Otherwise, the speaker or floor may be damaged or
injuries may result.
• Be careful not to pinch your hands or fingers when removing or attaching
the protectors.
• If the speaker is used with the protectors removed, carefully store the
removed protectors on a flat surface so they do not become deformed. Be
sure to store the protectors out of the reach of children so that they will
not damage them.

Specifications

Non-magnetic shielding type
- 100 kHz (–30 dB)
Tighten the terminal knob.
Simply insert the banana plug into the terminal.
Nominal input power ....................................................... 200 W
Maximum input power .................................................... 600 W
Sensitivity.........................................................88 dB/2.83 V, 1 m
Crossover frequency .........................................750 Hz, 4.5 kHz
Dimensions (W x H x D)
............................ 395 x 690 x 381 mm (15-1/2" x 27-1/8" x 15")
Weight.................................................................. 35 kg (77.2 lbs.)
Attaching the protectors
5
En