Angle Mount Cup Installation - Rainbow SL-C3.2 Einbauanleitung

Angle Mount Cup
Installation locations: Mirror corner, dashboard and rear package shelf
• Put the angle mount cup (O) on the installation place, scribe and finish the cable holes and mark the
drilling holes for the screws. Drill holes ∅ 3,5 mm for the angle mount cup screws and ∅ 8 mm for
the Tweeter screws.
• Fasten the angle mount cup (O) with the provided screw 3,9 x 13 (R).
• Insert the tweeter (J) into the angle mount cup (O) and pull the cables through the appropriate holes.
• Adjust the tweeter (J) to the cable holes in the angle mount cup (O). Press together and screw down
carefully only with the screw M4 x 6 (P) and the washer M4 (T). Caution! Do not tighten too firmly!
• Connect the tweeter according to the planned mode of operation active / passive with amplifier or
crossover and adjust the level (see page 16).
Figure 4: Angle Mount Cup installation for SL-T25
31