Flush Mount Installation; Angle Mount Installation; Cable Preparation - Rainbow Dream Line SLX 210 Einbauanleitung

Flush mount installation: Fig. 5
•
Place the flush mount cup (L) on the installation place. Scribe and cut-out mounting hole.
•
Place tweeter (J) on groundplate (U), pull cables through the appropriate holes and put flush mount ring
(L) over the tweeter and fix it by twisting.
•
Place complete tweeter in cut-out and fix it with ring (M) from the backside.
•
The tweeter can be moved in all directions now.
•
Connect the tweeter-cable with the crossover. The cable with the red marking is "+"
Angle mount installation: Fig. 6
•
Put angle mount cup (S) on desired installation place. Scribe the mounting holes and cable feedthrough and
drill them.
•
Fix angle mount (S) with the provided screws.
•
Twist the intermediate ring on the tweeter and pull it down to remove it.
•
Insert tweeter (H) into the angle mount cup (S) and push the cables through the cable feedthrough
•
Fix the tweeter (H) into the angle mount by twisting until it snap in.
Fig. 6: Angle mount installation
Attention: Use the provided assembly-kit for tweeter installation only!
Shorten tweeter cable (at least 1 mm²) to the appropriate length and strip both ends. Insert the red conduit cover (+)
over the appropriately marked conductor and the black cover (-) over the remaining conductor. Solder one end of
the stripped conductor with the u-shaped metal jacket. Provide suitable polarity plug contacts at the other end of the
cable, as well as the short connection cables of the tweeters.
Note: Attach tweeter only over the prepared connection cables, preferably with suitable plug contacts.
Soldering of the cables directly to the tweeter is not possible. The tweeter can be severely damaged by
the soldering procedure.
Shorten woofer cable (at least 2.5 mm²) to the necessary length to run from the woofer to the screw connections of
the crossover and strip at both ends. Insert the red conduit cover (+) over the appropriately marked conductor and
the black cover (-) over the remaining conductor. Equip both ends of cables with conduit covers provided and
solder to the u-shaped metal jacket.
Note: If cables with a larger diameter than 2.5 mm² are being used for the installation, they must be provided
with the appropriate u-shaped metal jackets according to DIN 46244. Cables should not be soldered at
the screw connections. The heat from soldering causes the screw connections to move out of position,
making misfires caused by poor contact unavoidable.
In general, the loudspeaker cables should be kept as short as possible and run in such a way that they are kept
separate from the auto's electrical system, thereby preventing distortion from the generator and electrical wiring.
The loudspeaker cables can also be twisted together to help prevent distortion. Rolling up excess loudspeaker cable
length is not helpful, as it merely increases chances of distortion.

Cable Preparation

10