Installing And Attaching The Woofer - Rainbow SL-C3.2 Einbauanleitung

Note: Do not attach via or puncture the membrane. Do not damage the membrane with a
screwdriver or other sharp tool.
• After selecting the installation location, attach the installation ring (C) at the designated location, e.g.,
with double-sided tape, and mark the necessary drill holes and the space for the woofer (inner circle
of the installation ring).
• Carefully prepare the space for the woofer and drill 2.5 mm holes. Smooth all metal edges, drill holes
carefully, and remove any metal shavings or pieces. As needed, apply a protective varnish or edge
protection.
• Insert self-tapping nut 3.9 (I) into the drill holes.
• Attach cables according to the instructions (see page 19/20) and appropriate polarity, and check the
woofer for accuracy of performance functions.
• Insert woofer (B) into the installation ring (C) and attach woofer into drill holes in such a manner that
the connections always lie freely. Under no circumstances should these make contact with
surrounding metal parts!
• Carefully attach the woofer with the enclosed self-tapping screws 4 x 30 (G) and using the washers
M4 (H). Align woofer, ensuring it lies flat, adjust to prevent unevenness through the supporting
rubber edge, and then tighten screws. Make sure that the woofer lies completely flat and may
not be turned by the screws otherwise the die-cast basket may break!
• Insert speaker cover (A), from above, perpendicularly into the installation ring (C) and firmly press.
Figure 2: Installing and Attaching the Woofers.

Installing and Attaching the Woofer

29