Rainbow SL-C3.2 Einbauanleitung Seite 33

Magnet Cup (Optional – Part No. 161254)
Installation locations: mirror corner, dashboard, windshield and center pillar
Put the magnet cup (N) on the installation place and center. Mark and scribe the drilling hole ∅ 5,3
•
mm and the cable holes.
• Drill the pilot holes for the screws and cables with a small drill. (Be careful with carpets as they are
easily damaged!)
Enlarge the drilling hole to ∅ 5,3 mm and finish the cable holes.
•
• Insert the tweeter (J) into the magnet cup (N) and pull the cables through the existing holes.
• Stick the threaded bolt (Q) with its M4 side through the magnet cup (N) and screw up with the
tweeter (J) . (There is a drilling device for the threaded bolt in the magnet bottom of the tweeter).
• Adjust the tweeter (J) and cables. Tighten the threaded bolt (Q) softly with a wrench (diameter 7
mm). Caution! Do not tighten too firmly!
• Attach the washer M5 (U) from behind to the threaded bolt and fasten it with the hexagon nut M5 (V).
• Should the length of the threaded bolt (Q) disturb the installation you can shorten it on the M5 side.
• Connect the tweeter according to the planned mode of operation active / passive with amplifier or
crossover and adjust the level (see page 16).
Figure 6: Magnet Cup installation for SL-T25
33