Installing And Attaching The Woofer - Rainbow Dream Line SLX 210 Einbauanleitung

Note: Do not attach via or puncture the membrane. Do not damage the membrane with a screwdriver or other
sharp tool.
•
After selecting the installation location, attach the installation ring (C) at the designated location, e.g. with
double-sided tape, and mark the necessary drill holes and the space for the woofer (inner circle of the
installation ring).
•
Carefully prepare the space for the woofer and drill 2.5 mm holes. Smooth all metal edges, drill holes carefully,
and remove any metal shavings or pieces. As needed, apply a protective varnish or edge protection.
•
Insert self-tapping nut 3.9 (I) into the drill holes.
•
Attach cables according to the instructions (pages 13/14) and appropriate polarity, and check the woofer for
accuracy of performance functions.
•
Insert installation ring (C) and the woofer (B) into drill holes in such a manner that the connections always lie
freely. Under no circumstances should these make contact with surrounding metal parts!
•
Carefully attach the woofer with the enclosed self-tapping screws 3.9x32 (G) and using the washers M4 (H).
Align woofer, ensuring it lies flat, adjust to prevent unevenness through the supporting rubber edge, and then
tighten screws. Make sure that the woofer lies completely flat and may not be turned by the screws.
•
Insert speaker cover (A), from above, perpendicularly into the installation ring (C), and firmly press.
Fig. 2: Installing and Attaching the Woofers.
Attention: Mounting of woofers with provided surround protecting washers only! (fig. 2c). Mounting the woofers
without surround protecting washer may damage the surround and void the warranty.

Installing and Attaching the Woofer

8