Philips HR 8775 Vision Gebrauchsanweisung Seite 4

English
• To enable recycling, the plastics of
the product have been coded.
• The cardboard packaging has
been made of recycled material
and is entirely suitable for recycling.
Important
• Before using for the first time, check if
the dustbag is placed correctly.
• Never suck up water (or any other
liquid). Never pick up ashes until they
are cold.
• When picking up fine dust, the pores of
the dustbag may become clogged. This
will obstruct the air passage.
Subsequently, the dustbag needs
replacement, although the bag might be
far from full.
• Only use this vacuum cleaner with the
special double-sided non-chlorine paper
dustbags type Philips Oslo + or Oslo +
Hygiene (closeable).
• Never use the vacuum cleaner without
the "Active Carbon" filter.
Getting the vacuum cleaner ready for use:
• Connecting the hose: press firmly ("Click!")
(fig. 1a).
- To disconnect: press the knob and pull the
hose out of the vacuum cleaner (fig. 1b).
• Connecting the nozzle, the telescopic tube
and the handle: insert the narrowed section
into the wider section (fig. 2).
• Adjust the telescopic tube ("Magic Tube") to
the required length (fig. 3).
• Nozzles:
- Combi nozzle. This nozzle is convertible for
use on either carpets (without brush, fig. 4) or
hard floors (with brush, fig. 5);
- Small nozzle, brush nozzle and crevice
nozzle. These can be found in the special
storage compartment (fig. 6-10);
• Pull the mains plug out of the vacuum cleaner
(fig. 11) and insert into the wall socket.
• Press the on/off switch (I) (fig. 12).
• The electronic suction power control on the
vacuum cleaner enables smooth suction
power adjustment (fig. 13).
MAX = maximum suction power.
MIN = maximum suction power.
- Move the slide towards MAX until the desired
suction power is obtained.
Medium suction power is advisable for
general use. (See also the section on the
f
Philips "Turbomax" motor.)
Minimum suction power is advisable for
dusting using the brush nozzle and for cleaning
curtains, cloths, etc.
Maximum suction power is advisable for
cleaning very dirty carpets and hard floors.
• The suction power control at the hand grip
enables you to reduce suction power (fig. 14).
This extra facility is advisable if you wish to
apply lower suction power for a short period.
Insufficient suction power?
Please check:
- if the slide on the vacuum cleaner is in the
required position;
- if the control at the hand grip is in "open"
position;
- if the dustbag is full;
- if the nozzle, tube or hose is blocked up.
To remove the obstruction, let the air stream in
opposite direction through the hose and/or
tube.
Automatic suction power control
The automatic suction power control adjusts the
suction power to the type of floor (hard floor or
carpet) and when the dustbag becomes full.
Automatic suction power control is advisable for
general use on floors.
Your vacuum cleaner is equipped with the
very powerful Philips "Turbomax" motor.
control will select medium suction power.
This will be quite enough for general use,
As the dustbag becomes more and more
full, the vacuum cleaner will automatically
select higher suction power. This ensures
4
Philips "Turbomax" motor
As long as the dustbag is more or less
empty, the automatic suction power
saves energy and makes vacuuming
easy.
that the dustbag will be filled entirely.