Getting Started; To Turn The Power On; Setting The Clock; General Control - Pioneer X-CM52BT-K Bedienungsanleitung

Getting started

Chapter 4:
Getting started

To turn the power on

Press the
STANDBY/ON
After use:
Press the
STANDBY/ON
mode.
Note
• In standby mode, if iPod/iPhone/iPad is connected, the
unit turns charge mode.

Setting the clock

STANDBY/ON OPEN/CLOSE
 
DVD/CD USB TUNER
AUDIO IN/LINE
BT AUDIO CLOCK/TIMER SLEEP
AUDIO SUBTITLE ANGLE
EQUALIZER
1 2 3
1 Press STANDBY/ON to turn the power on.
2 Press CLOCK/TIMER on the remote control.
"CLOCK" is shown on the main display.
3 Press ENTER.
4 Press to set the day, then press ENTER.
5 Press to set the hour, then press
ENTER.
6 Press to set the minute, then press
ENTER to confirm.
To confirm the time display:
Press the . The time display will appear for
CLOCK/TIMER
about 10 seconds.
To readjust the clock:
Perform "Setting the clock" from step 1.
Note
• When power supply is restored after unit is plugged in
again or after a power failure, reset the clock.
to turn the power on.
to enter the power stand-by
TOP MENU MENU/PBC
TUNE+
ENTER
HOME/MENU RETURN

General control

Input function

When the on main unit is pressed, the current function
INPUT
will change to different mode. Press the
select desired function.
DVD/CD FM
LINE AUDIO IN

Display brightness control

Press to dims the display brightness. The brightness
DIMMER
can be controlled in four steps.

Volume auto set-in

If you turn off and on the main unit with the volume set to 31
or higher, the volume starts at 30 and sets in to the last set
level.

Volume control

Turn the volume knob towards
press (on remote control) to increase or
VOLUME +/–
decrease the volume.
CAUTION
• The sound level at a given volume setting depends on
speaker efficiency, location, and various other factors. It
is advisable to avoid exposure to high volume levels. Do
not turn the volume on to full at switch on. Listen to
music at moderate levels. Excessive sound pressure
from earphones and headphones can cause hearing
loss.

Muting

The volume is muted temporarily when pressing the
the remote control. Press again to restore the volume.
repeatedly to
INPUT
USB/IPOD
BT AUDIO
(on main unit) or
VOLUME
on
MUTE
04
15
En