Christopeit Sport CS5 99252 Bedienungsanleitung Seite 18

Step 6:
Installation of the right footrest (18R) on the right footrest holder
(14R) and the left footrest (18L) on the left footrest holder (14R) with
the carriage bolts (17), the washers (24), spring washer (22) and the
handgrip nuts (23).
1. Push the right footrest (18R) onto the footrest holder (14R). Adjust the
holes in the parts so that they are aligned.
2. Push the screws (17) from above through the holes. Push on a washer
(24) and spring washer (22) from the opposite side, screw on a handgrip
nut (23) and tighten firmly.
3. Install the left footrest (18L) on the footrest holder (14L) as described in
1. – 2. (Note: The right and left footrests can be discerned by the edges of
the longitudinal sides of the footrests. The high edges of the footrests (18R)
and (18L) must point inwards (towards the main frame.))
Step 7:
Attach the computer (1) and hand grip bar (4) at support (64).
1. Take the computer (1) that has been supplied out of the packaging and
insert the batteries (Type "AAA"-1.5 V pencells) by watching for the right
polarity on the back of the computer (1). (Batteries for the computer are not
included in this item. Please buy them at your located market.)
2. Put the plug of connection cable (59) into the socket from monitor (1)
backside.
3. Insert the plug of hand pulse wire (2) to the jack of the monitor (1)
backside.
4. Attach the monitor (1) to top monitor bracket of front post (64) with screws
(39) and washers (35). (Attention: Ensure that the cable loom are not crunched
or pinched during installation.)
5. Place the hand grip bar (4) against the support (64) so that the holes are
aligned. Push a washer (69), spring washer (70) onto each screw (19) and
push them through the holes and tighten the handgrip bar (4) firmly.
18