Christopeit Sport CS5 99252 Bedienungsanleitung Seite 17

Step 3:
Installation of the handgrip bars (7) on the connecting tubes (11) with
bolt (63), washers (9) and
spring washer
1. Push the handgrip bars (7) onto the connecting tubes (11) and adjust the
holes in the tubes so that they are aligned.
(Note: the handgrip bars must be aligned after assembly so that the upper
ends are inclined outwards (away from the support (64)).
2. Push the bolt (63) through the holes and tighten the handgrip bars (7) with
washers (9) and spring washer (70) firmly.
Step 4:
Installation of the footrest holder (14) at the connecting tubes (11) with
bolt (13), washers (15) and nut (16).
1. Push the footrest holder (14R) at the connecting tubes (11R) and adjust
the holes in the tubes so that they are aligned.
2. Push the carriage bolt (44) through the holes and tighten the footrest
holder (14R) at connection tube (11R) with washers (69) and nut (45) firmly.
(This connection point has to move easily. So please don't tighten the
screw too much.)
3. Install the left footrest holder (14L) incl. all additionally required parts on
the left hand side of the machine as described in 1. – 2.
(70).
Step 5:
Installation of the footrest holder (14R) and the left footrest holder (14L)
with the connecting tubes (11) to the pedal crank and the support (64)
with the spring washers (70), the washers (49) and the screws (19).
1. Place the preassembled unit of the right footrest holder (14R) and one
connecting tube (11R) at the right hand side of the main frame (36).
(Note: Right is specified as viewed standing on the machine during
training.)
2. Push the connecting tube (11R) onto the shaft (67) of the support (64). Put
on the screw (19) a spring washer (70) and a washer (49) and tighten it firmly.
3. Put the foot pedal holder (14R) at the pedal axle (28R) and tighten them
with washer (20), spring washer (70) and screw (19) firmly.
4. Install the left footrest holder (28L) incl. all additionally required parts on
the left hand side of the machine as described in 1. – 3.
5. Now tighten the screws (63) of support (64) firmly. Push the plastic cover
(60) and rubber (61) into the right position of chain cover (21).
6. If the arms appear to move too much sideways, please carry out the
Following procedure; Remove the assembly bolt from either end of the Metal
shaft, place one or more of the 0.15mm spacers (80) provided on to The
shaft, as shown in the picture and then re-fit the assembly bolt.
7. Mount plastic cover set (79) to both side front end pedal bar (14) and
secure with 2 screws (46) for each side. Then put the screw caps for M10
(78) onto all M10 screw heads and nuts.
17