Service Data; Installation - Leonard LHN1110X Benutzerinformation

Problem
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
Steam and condensation set-
tle on the food and in the
cavity of the oven.

Service data

If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre.
The necessary data for the service centre is
on the rating plate. The rating plate is on
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

INSTALLATION

WARNING! Refer to Safety
chapters.
Building Under
CAUTION! Only a qualified and
competent person must do the
installation of the appliance. If
you do not contact a qualified or
competent person, the
guarantee becomes invalid if
there is damage.
Before you install the appliance, fit it with
the applicable hob from the table.
Possible cause
The oven is deactivated.
The fuse is released.
The lamp is defective.
You left the dish in the oven
for too long.
the front frame of the appliance cavity. Do
not remove the rating plate from the
appliance cavity.
.........................................
.........................................
.........................................
Type
LEM 6000 E
LES 6000 F
LES 6060 F
Electrical connection with the
hob
The hob connection socket is at the top of
the oven cabinet. The hob has connection
leads for the cooking zones and the ground
cable. The leads have plug-in connectors.
To connect the hob to the oven, plug the
connectors into the correct oven sockets.
Leonard 31
Remedy
Activate the oven.
Make sure that the fuse is the
cause of the malfunction. If
the fuse releases again and
again, contact a qualified
electrician.
Replace the lamp.
Do not leave the dishes in the
oven for longer than 15 - 20
minutes after the cooking
process ends.
Maximum power
7000 W
6000 W
7600 W