Service Data; Installation - Leonard LHN1313X Benutzerinformation

20 Leonard
Problem
The oven does not heat up.
The lamp does not operate.
Steam and condensation
settle on the food and in the
cavity of the oven.

Service data

If you cannot find a solution to the problem
yourself, contact your dealer or an
Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate is
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

INSTALLATION

WARNING! Refer to Safety
chapters.
Building Under
CAUTION! Only a qualified and
competent person must do the
installation of the appliance. If
you do not contact a qualified
or competent person, the
guarantee becomes invalid if
there is damage.
Before you install the appliance, fit it with
the applicable hob from the table.
Type
LES6001F
Possible cause
The fuse is blown.
The lamp is defective.
You left the dish in the oven
for too long.
Maximum power
6000 W
Remedy
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse is blown
again and again, contact a
qualified electrician.
Replace the lamp.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
on the front frame of the oven cavity. Do
not remove the rating plate from the oven
cavity.
.........................................
.........................................
.........................................
Type
LES6061F
LEM6001E
Electrical connection with the
hob
The hob connection socket is at the top of
the oven cabinet. The hob has connection
leads for the cooking zones and the
ground cable. The leads have plug-in
connectors. To connect the hob to the
oven, plug the connectors into the correct
oven sockets. The design of the plugs and
sockets prevents incorrect connections.
Maximum power
7600 W
7000 W