Clearing Taught Remote Controls; Other Settings; Setting Acknowledgement Tones - HomeMatic KeyMatic HM-Sec-Key Bedienungsanleitung

7.3

Clearing taught remote controls

Press the bottom button "Lock" for approx. 2 seconds.
Another long press of the button "Lock" (press button for approx. 2seconds)
ends the deletion process, without deleting a memory location (e.g. if the
button has been actuated accidentally).
If no button actuation occurs for 3 minutes after calling the menu, the menu
is exited automatically without deleting a memory location.
Proceed as follows for unteaching:
• The LC display shows "X", the symbols for radio reception and "Lock"
flash.
• Now, take the "Master" remote control and press any button (button must
be already assigned to the KeyMatic) until the "X" disappears and the first
memory location appears.
• Select the memory location to be deleted, e.g. "3" on the door lock drive
with the button "Lock" or "Unlock".
In order to delete the selected memory location, briefly press the small
"Setup" button on the door lock drive. When the deletion is successful, the
menu is exited with three short tone signals.
The door lock drive can no longer be operated with the deleted remote control. If a
lost or stolen remote control is found again, it can be taught for the door lock drive
as describe previously.Since copying the remote control is not possible, there is no
reason not to continue using it as usual!
Only the occupied memory slots are shown when deleting. If no remote
controls have been taught (factory status) or only the "Master" remote
control is taught, the display shows the message "MASTER". Deleting the
"Master" remote control (memory location "1") is not possible here.
7.4

Other settings

7.4.1

Setting acknowledgement tones

The acknowledgement tone for the door lock drive can be set to any of several vari-
ations. 4 different tone pitches and the "Sound off" option are available. Proceed as
follows to set the acknowledgement tone:
• Press the small "Setup" button.
• If the "X" is shown on the display, press a button on the Master remote
control (button must be already assigned to the KeyMatic), which selects
the next acknowledgement tone and outputs it for your approval. With the
"Sound off" option, the setting is acknowledged with a very short tone
signal.
• Going through the procedure again selects the next acknowledgement
tone.
44