Preparing Coffee; Steam Distribution; Drawing Hot Water; Turning Off The Machine - Bezzera MAGICA MITICA Bedienungsanleitung

01; pos. 9) and exhaust the steam 2 or 3 times in
the discharge basin.
The yellow light (Fig. 01; pos. 12), if on, points out
the machine is in working order; if off, it means
that the water level in the tank (S version), in the
boiler (R version) is not enough.
Warning:
- A safety device allows to stop the motor pump
after 120 seconds if the water minimum level
is not supplied to the boiler. The machine, as
alarm signal, turns off the lights.

5.3 Preparing coffee

1) Remove the filter holder (Fig. 01; pos. 7) from
the supply group.
2) Put the ground coffee into the filter holder,
press it and make attention that the filter hold-
er edge is not dirty with coffee.
3) Replace the filter holder in its housing.
4) Lift up the lever (Fig. 05) to obtain coffee dis-
pensing
5) To stop dispensing, when the desidered dose
is reached, take the lever back to downward
position, to allow the unloading of the group
and the drying of the coffee.
Caution:
- Do not remove the filter holder filled with cof-
fee when the equipment is operating.
- Do not touch expressly the metal plating of the
filter holder; danger of burns.
- The standard doses for the filters are 6/8 grams
for a dose and 12 grams for two doses.

5.4 Steam distribution

1) To avoid liquids being sucked into the boiler,
discharge the steam by turning the tap knob
(Fig. 01; pos. 9).
2) Insert the steam nozzle (Fig. 01; pos. 8) in the
container of the liquid to be heated.
3) Press down and hold the steam tap knob (Fig.
01; pos. 9), lifting the lever the tap will remain
in open position (Fig. 06). The amount of steam
distributed is proportional to the opening of
the tap; the more the tap is opened, the more
steam will be distributed.
(Fig. 06)
27
BEZZERA MAGICA - MITICA
MOD.
4) Once steam has been distributed, release
knob, remove liquid container and clean the
steam nozzle immediately with a damp cloth to
remove heated liquid residues.
Warning:
Do not touch the steam nozzle directly as it is hot.

5.5 Drawing hot water

1) Place the water container under the nozzle (Fig.
01; pos. 3).
2) Press down and hold the water tap knob (Fig.
01; pos. 10) to draw the amount of water re-
quired.
3) Once water has been distributed, release the
knob.
Warning:
Do not touch the water distributor tap directly as
it is hot.

5.6 Turning off the machine

1) Turn the main switch (Fig. 01; pos. 1) to position
"0" and check that the green light has turned
off. (Fig. 01; pos. 11)
2) Turn off the intercepting water tap (R version).

5.7 Pressure gauge

The machine is equipped with dual pressure
gauge by which you can check the following pres-
sures:
Boiler manometer (Fig. 01, pos. 14)
range 0~3 bar (0~0,3 MPa)
The boiler manometer indicates the boiler pres-
sure.
Pressure gauge (Fig. 01; pos. 15)
range 0~15 bar (0~1,5 MPa)
The pressure gauge indicates the pump maximum
pressure during operation. When the motor pump
is stopped the manometer indicates the water sup-
ply pressure (R version) or "0" (S version).

6 - MAINTENANCE

To allow the machine to work correctly, follow the
maintenance instructions provided below.