Plamen Barun 1 Technische Anleitung Seite 19

TECHNICAL DATA:
MEASUREMENTS W x H x D:
WEIGHT:
RATED OUTPUT:
FLUE OUTLET:
FUEL:
Barun 1
We are pleased to deliver this fireplace insert BARUN and put it at your disposal.
This fireplace insert is available in two different versions, with sheet metal shell and without
sheet metal shell. Your decision as to the more suitable version will depend on your heating
requirements. For more details, see "Fireplace selection".
To achieve the best heating efficiency and performance, please read carefully these Installation
and Operating Instructions.
The fireplace insert is made of high quality cast iron. Joints between individual component parts
are sealed with fire resistant coat. The door and the glass are sealed with fibreglass material. In
the lower part, there is an ash tray and primary air supply control. Above the door glazing
openings are provided for the supply of secondary air which supports the combustion and
prevents the glass staining.
In the upper part of the firebox, at the entrance into the flue outlet, a "by pass" damper is
installed, which should be opened only when you open the firebox door for the purpose of firing
or reloading. Its function is to prevent smoke from leaking into the room.
Output selection depends on the building insulation grade, weather conditions, exposure of the
building, in particular exposure to wind, etc.
The output of 1 kW is considered sufficient for the heating of a 10 m³ room, with a standard
height of 2,5 m.
For more details see the section entitled: "Space heating capacities".
SELECTION AND INSTALLATION
When installing the fireplace, make sure that relevant local, national and European regulations
are fully complied with. The installation shall be made in accordance with applicable civil
engineering regulations. Our liability shall be strictly limited to the delivery of this product in good
operating conditions. Therefore, after having unpacked the product, inspect it carefully for
possible damages in transport. Any such damages should be immediately reported, because
late claims will not be taken into consideration.
The fireplace shall be installed in accordance with these Instructions and building trade rules
and by qualified staff that shall be responsible for proper installation of the product.
750x620x500 mm
TYPE 1 125 kg TYPE 2 135 kg
8kW
Ø 180 mm
Wood
Barun 2
19