Electrical Connection - AEG SK 78840-6E Gebrauchsanweisung

Electrical connection

Before plugging in, ensure that the voltage and frequency shown on the
serial number plate correspond to your domestic power supply.
Voltage can vary by ±6% of the rated voltage.
For operation with different voltages, a suitably sized auto-transformer must
be used.
Important
The appliance must be earthed.
The power supply cable plug is provided with a contact for this purpose.
If the domestic power supply socket is not earthed. connect the appliance to
a separate earth in compliance with current regulations, consulting a
specialist technician.
The Manufacturer declines all responsibility if the above safety
precautions are not observed.
This appliance complies with the following E.E.C.
Directives:
- 87/308 EEC of 2/6/87 relative to radio interference suppression.
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and subsequent modifications.
- 89/336 EEC of 3.5.89 (Electromagnetic Compatibility Directive) and
subsequent modifications.
Attention!
It must be possible to disconnect the appliance from the mains power supply;
the plug must therefore be easily accessible after installation.
46