Installation / Positioning - AEG SK 78840-6E Gebrauchsanweisung

Installation
Take utmost care when handling your appliance so as not to cause any
damages to the cooling unit with consequent possible fluid leakages.
During normal operation, the condenser and compressor at the back of the
appliance heat up considerably. Always ensure that there is adequate
ventilation as a failure to do this will result in component failure and possible
food loss. See installation instructions.
Important: if the supply cord is damaged, it must be replaced by a special
cord or assembly available from the manufacturer or its service agent.
Positioning
Unpack the cabinet and check that it is in good condition and free of any
transport damage.
The appliance must not be located close to radiators or gas cookers.
Avoid prolonged exposure of the appliance to direct sunlight.
For safety reasons, minimum ventilation must be as shown in Fig.
Attention: keep ventilation openings clear of obstruction.
It is necessary that the niche is provided with a conduct of venti-lation
having the following dimensions:
Depth: 50 mm
Width: 540 mm
The climate classification can be
found on the rating plate, which is
located inside the cabinet on the left
hand wall.
The following table shows which ambient temperature is correct for each
climate classification:
classification
Climate
SN
N
ST
T
for an ambient
temperature of
+10 to +32 °C
+16 to +32 °C
+16 to +38 °C
+16 to +43 °C
45