And Ventilation; Installing The Appliance; Connecting The Appliance - Bosch GTM Serie Gebrauchsanleitung

Installing the appliance

Install the appliance in a dry, well
ventilated room. The installation location
should neither be exposed to direct
sunlight nor near a heat source, e.g.
a cooker, radiator, etc. If installation next
to a heat source is unavoidable, use
a suitable insulating plate or observe the
following minimum distances to a heat
source:
3 cm to electric or gas cookers.
30 cm to an oil or solid fuel cooker.
The floor of the installation location must
not give way; if required, reinforce floor.
Align appliance with a spirit level.
If the floor is uneven, compensate with
supports.
The appliance can be transported on its
smooth running rollers. Fig. 4
Warning!
!
If required, secure the appliance
to prevent it from rolling away.
If the appliance is placed next to the wall,
there must be a minimum distance of
70 mm between the wall and rear panel
or side panels.
Removing
the transportation
protection devices
Remove the four transportation protection
devices, Fig. 3, which are attached
between the chest freezer lid and
appliance.
Insert two of these transportation
protection devices into the designated
holders at the back of the appliance.
This maintains the minimum distance
between the appliance and the wall, the
chest freezer lid can be opened correctly
and ventilation is guaranteed.
Connecting
the appliance
After installing the appliance, wait at least
½ hour before switching on the appliance.
During transportation the oil in the
compressor may have flowed into
the refrigeration system.
Before switching on the appliance for the
first time, clean the interior (see Cleaning).
The socket should be freely accessible.
Connect the appliance to 220-240 V/
50 Hz alternating current via a correctly
installed earthed socket. The socket must
be fused with a 10 to 16 A fuse.
For appliances operated in non European
countries, the identification plate should
be checked whether the electric supply
and the current model stated match the
vales of the mains supply. These specifi
cations can be found on the rating plate.
Fig. q
The mains connection cable may be
replaced by an electrician only.
Warning!
!
Never connect the appliance to electronic
energy saver plugs or to power inverters
which convert the direct current to 230 V
alternating current (e.g. solar equipment,
power supplies on ships).
en
19