Seca 701 Bedienungsanleitung Und Garantieerklärung Seite 175

Additional notes on scales with printer interface
You have purchased an electronic personal scale with a serial printer interface. At the bot-
tom of the scale head (see illustration), a 9-pole sub-D plug is provided via which an
"EPSON" compatible printer can be connected. For further details please consult the seca
customer service.
For details on how to install and set a printer into operation, please refer to the relevant
operating instructions.
Functional description and operating conditions
The scale with printer interface is provided with an automatic print function to document
the weighing results. This does not affect the operation and function of the scale.
Printing is possible as soon as the printer has been correctly connected to the scale via
the printer cable (and locked using the screw bolts) and the following conditions are
satisfied:
– Scale and printer are on
– Printer is in online mode
– The following printer parameters habe been set:
– Baud rate:
– Data bit:
– Parity check:
– Parity:
– Handshaking:
– Receive error:
– Buffer capacity:
– Handshaking operation:
A weighing result is automatically printed once you have stepped onto the scale and the
display has stabilized. When you hear that the printer is activated, you can step off the
scale. Each printout bears the seca logo.
Please note that when several prints are made in succession,
played. Otherwise, another output cannot be printed.
Model 7017021904 / -994
Screwbold for locking the
printer cable
9600 bps
8 bits
enabled / yes
even
XON / XOFF
prints '?'
maximum
receive buffer full
key: flush type
9-pole sub-D plug
0. 0 0
(no load) is briefly dis-
GB
175