8. Open the doors of the appliance and the built-in unit (90
square B in the guide A. Press the doors together and mark the holes (look at
figure below). Remove the squares and drill the holes with a diameter of 2 mm
in a distance of 8 mm from the outer edge of the built-in unit. Insert square B
in the guide A again and fix it with the screws.
9. Fix cover D on B so that it snaps
10. Now fix the appliance on the built-in unit. The distance appliance (handle side)
to Built-in unit must be 5 mm. The door must close properly. Fix the covers of
the feet and the sealing ledge.
sluggishness of the door.
Disregarding these instructions will lead to:
37
0
). Insert the small