Customer Service - AEG Electrolux A 40110 GT Benutzerinformation

24
What to do if...
Problem
The lid doesn't close com-
pletely
The lid is difficult to open The lid gaskets are dirty or sticky Clean the lid gaskets
It is too warm in the
freezer
It is too cold inside the
freezer
The appliance does not
work at all. Neither cool-
ing nor lighting works

Customer Service

If your appliance is still not working properly after making the above checks, contact the
nearest service centre.
Possible cause
There is excessive frost
The lid gaskets are dirty or sticky Clean the lid gaskets
Food packages are blocking the
lid
The temperature is not set cor-
rectly.
The lid does not close tightly or
it is not shut properly
Before freezing the appliance
was not precooled sufficiently
Large quantities of food to be
frozen were put in at the same
time
Food placed in the appliance
was too warm
Products to be frozen are
placed too closely to each other
The lid has been opened often
The lid has been opened for a
long time.
The temperature is not set cor-
rectly.
Plug is not connected to the
mains socket properly
Power does not reach the appli-
ance
The appliance is not switched on Switch on the appliance
There is no voltage in the mains
socket (try to connect another
appliance into it)
Solution
Eliminate excess frost
Arrange the packages in the
right way, see the sticker in the
appliance
Set a lower temperature
Check if the lid closes well and
the gasket is undamaged and
clean
Pre-cool the appliance for
enough time
Wait some hours and then check
the temperature again. Next
time insert smaller quantities of
food to be frozen at any one time.
Allow food to cool to room tem-
perature before storing.
Place the products in a way so
that cold air could circulate
among them
Try to not open the lid often
Do not leave the lid open longer
than necessary
Set a warmer temperature
Connect the mains plug properly
Try connecting another electrical
device to the power outlet
Call an electrician