Troubleshooting; Transport; Storage - Honda HRD536HXE Betriebsanleitung

TROUBLESHOOTING

Incident
Engine does not start. 1. No fuel.
2. The throttle control lever is in the
"STOP" position.
3. Fuel shut-off valve is closed.
4. Spark plug cord incorrectly
attached or disconnected.
5. Spark plug defective or incorrect
electrode gap.
6. Engine flooded.
Hard starting or loss 1. Dirt in petrol tank.
of power.
2. The air cleaner is dirty.
3. Water in petrol tank and
carburetor.
4. Vent in fuel cap and/or
carburetor clogged (*).
Erratic operation. 1. Spark plug faulty or improperly
gapped.
2. The air cleaner is dirty.
Engine overheats. 1. Spark plug improperly gapped.
2. The air cleaner is dirty.
3. Dirty cooling fins (*).
4. Low oil level.
5. The flywheel's protector grid,
located under the recoil starter,
is restricted by blades of
grass, etc.. (*)
Excessive vibration. 1. Loose blade or engine mounting
bolts.
2. Blade unbalanced.
(*) Maintenance of these points must be entrusted to an approved
Honda dealer unless the user has the necessary tools and is
mechanically competent.
12 EN
Probable cause

TRANSPORT

Page
Do not tilt the mower since this may cause fuel
4
or oil spillage ; spilt fuel or even fuel vapours are a fire hazard.
6
TO TRANSPORT THE MOWER
6
1. Place the throttle control lever in
-
"STOP" position.
2. Pull off the spark plug cap.
9
3. Close the fuel shut-off valve .
To facilitate the operation, remove
6
the grass bag (see page
NOTE: When folding the handle,
check that the cables are not
-
knotted, twisted or too tight.
8
HRH536:
-
4. Loosen the four fixing screw [1]
to fold the handle.
-
HRD536:
4. Unscrew the knobs [2], remove
the screws and fold handle [3].
9
8
9
LOADING THE MOWER
8
CAUTION:
-
• To prevent losing control of or damaging the mower, do not use
the drive system when going up or down a loading ramp.
6
• To prevent damaging the drive system, do not engage the clutch
-
when the mower is rolling backwards.
• Transport the mower in normal horizontal position with its four
wheels flat on the vehicle platform.
• We recommend that you use a loading ramp or that you get
someone to help you load and unload the mower.
• Adjust the loading ramp so that it is inclined at an angle of less
than 15°.
10
• When transporting the mower, immobilise it using straps and
place chocks under the wheels.
10
• The straps must not touch the following parts of the mower:
throttle control lever, blade clutch lever, fuel tank and all the
control cables.

STORAGE

PREPARATIONS FOR STORING
THE MOWER
Carry out the following operations to protect the mower each time it
is to be stored for a period of more than 30 days.
Do not drain the fuel tank while the muffler is hot.
[1]
4).
[2]
[2]
SAFETY
C19
SAFETY
[3]
B3 D2
D3 D4