Inhaltsverzeichnis
Werbung
USER MANUAL
channel is used solely for a 0% to 100% switch. Before applying power to a fixture,
check that the source voltage matches the fixture's requirement.
The unit is sup plied with a po wer plug appropriate to its voltage and
destination. Should any other connections be required they must be
carried out with the following configuration.
Cable(EU)
Brown
Liht blue
Yellow/Green
DMX-512 connection between fixtures
The fixture is equipped with 2-pin XLR sockets for DM X input and output. The
sockets are wired in parallel. Only use a shielded twisted-pair cable designed for
3-pin XLR-plugs and connectors in order to connect the controller with the fixture
or one fixture with another.
Occupation of the XLR-connection
Caution: At the laser fixtur e, the DMX-cab le has to terminated with a
terminator. Solder a 1 20 Ohm resistor bet ween Signal (-) and
Signal (+) into a 3-pin XL R-plug and pl ug and plu g it in the
DMX-output of the last fixture.
Cable(US)
Black
White
Green
9
Pin
International
Live
Neutral
Earth
L
N
Werbung
Inhaltsverzeichnis
