Installation On A Stand Or Speaker Stand - Omnitronic AS-800 Bedienungsanleitung

5.3 Installation on a stand or speaker stand

The installer is responsible for adhering to the carrying capacity given by the manufacturer, the safety
requirements and the qualification of possible co-workers.
When people are located below the load, all necessary safety measures have to be taken in order to avoid
injury.
The personnel has to be instructed on the content of the user manual and on the dangers related with
operating stands.
Depending upon the individual installation spot, all necessary measures against movement and for securing
the standing safety have to be created.
The installation is only allowed on carrying areas. In some cases, an appropriate substructure, e.g. via an
balancing foot, has to be created.
The system must never be moved before the top speaker is uninstalled!
When choosing the installation material, optimum dimensions have to be chosen in order to secure
maximum safety.
If installing on slippery surfaces, the legs must be secured with screws or nails via the provided
holes or an anti-slippery mat has to be used.
Stands or satellite systems must only be installed
on a plane area with a maximum inclination angle
of 5°.
Caution: Speaker systems installed on stands or
satellite systems may cause severe injuries when
crashing!
When using stands or satellite systems under the
influence of horizontal forces, e.g. through wind, the
standing safety can be impaired. This is why
additional safety measures like attaching ballast
weights have to be taken.
If inclined tension cables or prolonged outriggers
are used, the area of danger has to be marked or
even be blocked.
Before lifting or lowering the telescopic tubes, you
must always block a safety area around the stand
or satellite system. This safety area must have a
diameter of 1.5 times the maximum height.
Lifted telescopic tubes always have to be secured
with a secondary securing!
The total weight of the installation (=total weight of
all individual parts) must never exceed the
maximum load of the installation area.
The stand has to be installed out of the reach of people.
An unintended movement of the load has to be avoided - also in case of fire!
DANGER!
25/31 00074230, Version 1.0