IKEA FRAMTID Bedienungsanleitung Seite 11

ENGLISH
• Clean the oven with a soft cloth with warm
water and soap and leave it to dry .
Accessories
Clean all slide-in units with a soft cloth with
warm water and soap (shelf, baking tray, shelf
support rails etc.) after each use and dry well.
Soak briefly to make them easier to clean.
Cleaning the oven door
The oven door has two panels of glass installed
one behind the other. To make the cleaning
easier remove the oven door and the internal
panel of glass.
Warning! The oven door can close if you
try to remove the internal panel of glass
when the door is still assembled.
Removing the oven door and the glass panel
1
Open the door fully
and hold the two
door hinges .
3
Close the oven door
to the first opening
position (approx.
45°). Then pull for-
ward and remove it
from its seat.
2
Lift and turn the lev-
ers on the two hinges.
4
Place the door on a
stable surface pro-
tected by a soft cloth.
5
Release the locking
system to remove the
internal panel of
glass.
7
90°
Turn 2 fasteners by
90° and remove
them from their seats.
Clean the glass panel with water and soap.
Dry it carefully.
Inserting the door and the glass panel
When the cleaning procedure is completed,
insert the glass panel and the oven door. To
do so, follow the steps in reverse.
The inner glass panel must be assembled
keeping the decorative frame (screen-print-
ing) turned towards outside of the oven. To
double check you did the above operation in
a proper way simply pass your fingers on the
inner glass surface. If the panel of glass is as-
sembled correctly you should not feel any
roughness.
Insert the internal panel of glass into the right
seats as shown below.
11
6
8
2
1
Carefully lift and re-
move the panel of
glass.