Omnitronic EM-650 Bedienungsanleitung Seite 16

12. TALKOVER-BUTTON
Press this button if you want to use your microphone. When the button is pressed, all signals but the
microphone level are attenuated by 15 dB.
13. CHANNEL-FADER
Used to adjust the input level of each channel.
14. CUE-BUTTON
Use the CUE-button in order to select the channel(s) to be monitored.
15. PHONO / LINE / MIC-SWITCH
Used to select the input to be sent to the individual channel.
16. SIGNAL LED
17. ZONE-SELECT-BUTTONS
Route the channel signal to zone 1,2,3.
18. OUTPUT LEVEL-CONTROL
With the OUTPUT LEVEL-control, you can adjust the output level of the individual channel.
19. MASTER-BASS-CONTROL
Used to increase or lower the LOWs of the output signal.
20. MASTER MIDDLE-CONTROL
Used to increase or lower the MIDs of the output signal.
21. MASTER-TREBLE-CONTROL
Used to increase or lower the HIs of the output signal.
22. CHANNEL DISPLAY
The display shows the individual channel signal.
23. PHONE LEVEL-CONTROL
With the Level-control, you can adjust the phones volume without changing the output signal.
24. HEADPHONES-SOCKET
Use this socket to connect the headphones. Headphones from 8 Ohms to 600 Ohms can be used.
25. CUE MIXING-FADER
Connect your headphones to the HEADPHONES socket. With the CUE-buttons, you can select the desired
channel.
When you set the CUE MIXING-fader to PGM (CUE-buttons without function), you can cue the output signal
of the mixer.
When you set the CUE MIXING-fader to to the center position, you can cue both the channel-signal you
selected and the output-signal.
26. REC SELECT
For selecting the channel routed to the Master signal.
27. REC OUT
To connect your recording unit.
16/19 10007110.DOC