Connection With The Mains; Operation; Cleaning And Maintenance - EuroLite Mirrorball-Set 30 Bedienungsanleitung

Insert the fourth chain link of the mirrorball chain with the mirrorball in the screw-on chain link and tighten the
fixation screw.
For overhead use, always install a safety chain on the mirrorball that can hold at least 12 times the weight of
the installation. The safety chain must be slightly longer than the mirrorball chain so that the safety chain will
always be tension-free. Pull the safety chain through the safety eyelet of the mirrorball and in the safety
eyelet of the motor.
There must never hang a mirrorball or other load at the safety eyelet. Loads must only be hanged at the
quick link of the installation eyelet at the motor axle. If a mirrorball hangs for any reason at the safety eyelet,
the motor must be taken out of operation immediately and the mirrorball must be uninstalled. The whole
installation has to be checked for defects by an expert.
Make sure that the rotation of the mirrorball is never slowed down or stopped by decoration material etc.
Make sure that no side forces can impact on the installation.
Make sure that the mirrorball cannot be moved by air streams. The mirrorball and the motor must be installed
and operated absolutely swivel free.
Please check in regular intervals, if the installation material (e. g. key ring, shackles or screw-on chain links)
or chain links have been deformed. Uninstall the mirrorball immediately in such a case.

Connection with the mains

Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
Before taking into operation for the first time, the installation has to be approved by an expert!

OPERATION

After you connected the devices to the mains, they start running. The lamp begins to burn and the colour-
wheel rotates at 4 RPM. If the light beam is directed towards the rotating mirrorball, a beautiful and
alternating effect is created.

CLEANING AND MAINTENANCE

The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tighly connected and must not
be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).
International
L
N
DANGER TO LIFE!
20/42 50101860_V_1_2.DOC